Preventative Water Heater Maintenance in 10 Minutes

Posted by on Sep 24, 2014 in Water Heater Repair Smyrna GA | 0 comments

Water heater maintenance in ten minutes? Yep, that is correct. Water Heater Repair Smyrna GA is going to show one how to carry out some water heater preventative maintenance. And, that’s all it will take to complete these 2 essential water heater upkeep tasks; nonetheless, we understand that these will do an outstanding job of assisting with three things:

  • Having a water heater last much longer for it will save on money with running it.
  • Seeing to it ones water heater runs safely is critical for we do not want it to explode in your home.
  • And having it run as energy efficiently as possible also helps one conserve one some cash.

We are now prepared to spend ten minutes once or twice a year to assist in saving some cash on energy costs.

Testing the T&P Relief Valve
The T&P Valve, also referred to as the temperature and pressure relief valve, has a crucial task. It’s job is to help make sure excess pressure inside the water storage tank does not develop, or in even more easy terms, it makes certain that ones water heater does not explode. The T&P valve has a lever or little handle. All one has to do is lift it some and afterwards let go of it back. It should snap back to its closed position quickly. A little water may be heard entering into the drain pipe below the lever that was just raised and maybe heard some pressure being released also. If none of these things have actually taken place throughout the test, the valve will have to be replaced.

Carry out a Mini Water Heater Tank Flush
Naturally, rust and corrosion will take place inside the water storage tank because of the chemical reactions taking place with all the components inside that are required to warm water. We will not get too technical here, but it is simple to help avoid this process by doing a flush or draining of all or a portion of the water in the storage tank.

For simply a small flush, place a container under the drain valve below the tank. Open the drain valve and fill up the container with water. Drain a minimum of a couple of gallons of water in total. Let the water sit in the pail for a few minutes to settle and analyze if there is much that settles to the bottom of the bucket. If there is, if the water heater has actually not been drained for a very long time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature dial down and might wish to let the water cool down for about an hour initially so it is not too hot while draining it. Likewise, it would be much easier to attach a hose to the drain valve and let the water go outside rather of using pails.

If the water looks fairly clean and clear from the tiny test you should be all set. When the water heater has a large amount of sediment inside of it, it can make loud popping noises and it reduces its effectiveness too.

Though water heaters are fairly maintenance free and uncomplicated to run, whenever one feels the tiniest uneasy or are unsure of what to do, it is always best to have give Water Heater Repair Smyrna a call to assist with ones regular water heater maintenance.

Here is an infographic that illustrates these steps, and check out our blog more water heater tips and advice.

Water Heater Repair Smyrna GA